These are Porsche seats of a continuous customer we have had over the years. He took Porsche seats from another car, that had the original seat heaters in them and actually had lumber supports, which was completely UN-heard of back in the 60’s & 70’s. The seats were custom cut and fir in a burgundy leather and as you can see, came out beautifully. The owner was ecstatic.

This is a custom Clear convertible top on a 1962 Chevy Impala SS. The customer wanted something very extreme and very unique. This is again, going to be a very difficult install. Since the top is clear, it could easily get scratched or damaged, so this is going to take the whole table being covered with cloth, so that when it is being stitched, it can slide without getting any scratches in the material.

This is a ’40’s Ford Convertible, that had a custom interior put into it. As you can see, the door panels, Dash, carpets, seats and door panels were all custom fitted and made. The pattern is one of a kind custom made for this car. The convertible top was also made and done from scratch.

This is the complete custom VW Bus that is finally completed. We did the complete interior, which as previous pictures showed is all custom but the look holds the original charm of the era. Some photos of the outside were taken to show all the work that went into this project. The last three show the interior shots which we handled. The second from the right, is a picture of the headliner, which needed to be hand stretched to fit and then installed. The far right is a the interior panel that the table connects to and the table. The very last picture is of the back deck cover where the bed lays, along with the trunk panels. More photos to follow.

This is custom Porsche 911 Cabriolet conversion that we put a new convertible top  that I recommended to the customer, since the car was custom, to do a 993 style design top to replace the earlier look with something more modern.

This is a custom hand stretched Leather dash on a 1957 300SL. This is applied to the metal directly and needs to be per-formed before attaching to the car. This is extremely hard to do and takes a lot of patience and care when installing.

Here is a pic of a Porsche 911 Steering Wheel, that was hand crafted from scratch and is being Hand stitched. This takes precision and is time consuming, to ensure stiches are evenly spac

Here is the actual BMW Z-3, that the seats go to and that the Convertible Top is also going to be replaced on. Here is the view of the Top completely Off and ready for the New One to be Installed.